Turn the bottom plate upside down (rivnuts will be facing
up) and place the locking washer and flat washers on to
the following screws as shown below. Push the M4x35mm
black Alloy Screws through the holes indicated with a green
circle below. Push the M4x35 Ti through the remaining holes.
Flip plate over and slot the Boom Bracket Inners onto the Ti
screws. Put Center Plate Spacers over the remaining black
screws.
NOTE:
For this model the
curve of boom brackets face
inward following the curvature
of the plate.
12
Place the remaining Boom Bracket Inners on top of the Booms
through the screws.
Lay the booms over the protruding screws as shown. You
will notice both ends have holes drilled.
Please ensure you use the holes that are closest to the
end of the boom.
These holes are 11mm from the edge.
Flip the setup over, place the top centerplate on and fasten
the boom cluster screws. Be carefull that all brackets stay in
place.
TIP:
Slide a piece of cardboard underneath to flip over.
OR:
Instead of flipping the setup over you can slide each bolt
to the edge of your bench and tighten from underneath.
Summary of Contents for SkyJiB X4 XL
