53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
64
68
68
53
54
55
54
104
Glue mahogany strips 53 to 55 into notches of formers.
Glue magnet 104 precisely into rectangular marking on
underside of part 49 and remove any surplus glue around
magnet.
Make up two corner pieces from three parts 50.1 each,
then glue corner pieces to base plate 49 and rear of former
52.
Carefully sand complete hood structure and cover with
Oratex.
49
50.1
28
Glue together the fin from parts 53 to 61. Bevel top edge of part 54 (see red marking) to fit part 57.
Make sure to glue parts 54, 55, 56 and 61 at an angle of 90° to part 53.
29
Glue parts 62 to 68 to either side
of part 59.
30
88
88
88
89
89
93
93
93
105
106
106
Carefully round off the shape of the fin, then cover with Oratex.
31
Attach steering frame 105 with screws 88 and
stop nuts 89 to base plate of outboard motor.
Attach blocks 106 with screws 88 and nuts 89
to frame 105.
Connect steering wires 93 with Z-bends to frame
105.
Adjust motor mount so that the bottom
of the prop hub is level with the bottom
of the hull.
32
33