- 3 -
(1) Wing
(2) Tail Vertical Stab Set
(3) Tail Horizontal Stab
(4) Fuselage Nose
(5) Fuselage Turtle Deck
(6) Servo Fairing Set
(7) Push rod, Clevis and Control Horn (2 aileron sets, 1 elevator set)
(8) Hook-and-loop tape (2 battery sets, 1 receiver set)
(9) Decal sheet
(10) Motor Mount with screw set (4pcs)
ADDITIONAL ITEMS REQUIRED
Propulsion1:
28mm Outrunner matched with a 6” Prop for 2-3cell LiPo
Propulsion2:
20-28mm Inrunner matched with a 4” Prop for 2-3cell LiPo
Radio:
Minimum 3 channel
Servos:
2 x (HITEC HS-55 or equiv) for ailerons and elevator
Gyro:
Optional(GWS PG-03, Esky EK2-0704 or equiv)
Servo Extension 15”:
one required
Aileron Y-cable:
one required, 2” minimum length
Adhesive:
Use any type of medium or thick cyano-acrylate adhesive.
Do not use
styrofoam cyano.
Alternately, you may use a low temperature, foam safe hot glue.
Tools:
Scissors, hobby knife, 3/32” & 5/32” diameter drill
INSTALLING THE SERVOS
Set the servos to center from the transmitter, or use a servo tester. Fit the output arms
on the servos at 90˚ to the case sides. If using CA glue, wrap adhesive tape around
each servo, or shrink a heat-shrink sleeve around the case.
This helps prevent adhesive
from entering the servo.
Spray activator on the prepared servo and allow it to air-dry.
Apply thick cyano to the servo recess only where the servo is protected by the tape or
shrink sleeve. Install the elevator and aileron servos as shown. Tape servo fairings in
place to cover each aileron servo.
INSTALLING THE MOTOR MOUNT
Align the motor mount straight and true with the back flat surface of the wing. View
from top, side and rear to confirm the mount is straight and true from each view. Fix
its position and drill 1/8” pilot through holes using the bracket holes as a template. Then
remove the bracket and widen the holes with a 5/32” drill through.
Insert the mating retainer from the underside with the
longer stand-offs piercing the
thickest portion of the wing
. If you wish to route the motor wires through and
underneath the bracket, you must install the motor before screwing the top bracket down.
- 6 -
