Fig 7: Device choosing window
Altis Micro window
There are two parts of the window. The upper part shows general information about the device – its
firmware version, serial number and used memory.
The bottom part of the window is used for settings.
Downloading data
In order to access the logged data from your Altis Micro, use the
Download data
button. Once the data is
downloaded, you can close the Device window and work with the data.
Settings
There are many possible configurations for the Altis Micro. You can set your Altis Micro according to your
needs. This is done by using the settings tabs in the bottom part of the window.
There are several tabs:
Logging Settings
(Fig 8) – Here you can set how you wish to store the flight parameters to your device
memory. The basic parameter, Sample time, determines how frequently the parameters will be logged.
You can set which parameters you wish to log. You can log altitude, temperature of the device (note: the
device is usually several degrees warmer than its environment), input throttle PWM (signal from the R/C
system), output throttle (signal to ESC) and the voltage on board (the voltage Altis Micro is powered from).
Note that the more parameters you log or the lower the sample time is, the more memory it consumes.
However, there is memory enough to log about 15 hours of data when logging almost all available
AerobTec Altis Micro User Manual
9