There are also several preset competition formats (F5J, ALES150, ALES200) from wich can user select.
At the bottom of the Competition Settings tab there are Safety and Training settings.
Allow Emergency
Motor On
has the following function:
In some competitions it is not allowed to switch the motor on again during the flight. However, you may
want to have the ability to switch the motor on again in an emergency situation. The user can choose to
enable this or not. If enabled, when the motor is switched on for an emergency the Altis Micro restarts the
recorded F5J height and it is recorded so it can be shown on the flight graph.
Sometimes during training it is not practical to reset your Altis Micro to start a new flight each time you
land and launch again. In this case there is the option:
Allow Competition Restart.
It
makes the device
behave as if it has just been initialized (only for the competition settings) when your plane’s altitude drops
below 8m.
If user uses Altitude Switch there is possible to activate
Antizoom algorithm
. Its purpose is to take into
account the ascending of the model, so the model will fly only to the specified switching altitude after the
motor is turned off while ascending.
The antizoom gain specifies the influence of the vario for the calculation of the moment of motor off. The
higher the number (maximal value is 2.55), the more vario is taken into account. If antizoom gain is 0, the
model behaves as with deactivated antizoom algorithm.
Note: there are several types of firmware. Some firmware types will not allow certain setting changes.
Refer to the Firmware types
chapter
for more information.
Fig 9: Competition Settings
Other settings
(Fig 10) – You can assign a function for the selected port and change LED Display
settings.
You can choose from
None - inactive
JETI Model Duplex EX
Multiplex MSB
Live Output – for online output of measured data
AerobTec Altis Micro User Manual
11