4
4. Plug into any standard polarized 240 Volt AC electrical outlet.
This product electrical rating: 230 VAC, 50 Hz, 0.55 A.
Note: Because this is an electric device,
ensure your hands are dry when connecting
the cord set to the pump or plugging it into
the wall outlet.
5. Turn dial on pump to “Inflate” position. Bed will inflate hands-
free. When desired firmness is reached, turn dial to neutral
position (Off).
6. To adjust firmness level, slowly turn dial on pump to silent
adjust position (see figure Adjust). Pump will slowly release
air. Turn dial to neutral position once you reach your desired
firmness level. To add more air, repeat Step 5.
IMPORTANT: PUMP HAS RESETTABLE FUSE
WITH AUTO SHUT-OFF FEATURE. IF PUMP
RUNS FOR APPROXIMATELY 5 CONSECUTIVE
MINUTES, THE AUTO SHUT-OFF FEATURE WILL
ENGAGE WHICH WILL ALLOW THE MOTOR TO
COOL. PUMP WILL AUTOMATICALLY RESET
ITSELF IN APPROXIMATELY 30 MINUTES.
This is the closed position.
Open Quick Release Valve.
Close valve using 2 thumbs.
Adjust
Make sure product is completely dry and clean before deflating and storing.
1. To deflate your AeroBed
®
product, open the Quick Release Valve.
2. For most compact storage, close Quick Release Valve, plug
power and turn dial to Deflate. Once excess air is released, turn
dial to neutral position (Off).
3. Roll or fold the AC cord and secure it. Fold sides of bed into the
center along its length. Tightly roll and place bed in convenient
carry bag for easy storage and transport.
4. Store your bed in a clean, dry place at room temperature
(above 50 °F / 10 °C). Storing your bed under 50 °F (10 °C) and
over 100 °F (38 °C) may affect its performance and will not be
covered under warranty.
DEFLATION AND STORAGE