3
IMPORTANT:
THE FIRMNESS OF YOUR AIRBED MAY
DECREASE AFTER YOU INITIALLY INFLATE IT. YOUR AIRBED
IS NOT LEAKING. THIS IS NORMAL AND IS CAUSED BY THE
MATERIAL STRETCHING AFTER THE AIRBED IS INFLATED.
ADD AIR TO MAINTAIN YOUR DESIRED FIRMNESS.
NOTE:
BED MUST BE AT ROOM TEMPERATURE PRIOR
TO INFLATING OR IT MAY CAUSE AIR LEAKS. PRESSURE
CAN VARY DEPENDING ON ROOM TEMPERATURE AND
CONSUMER WEIGHT.
1. Place your rolled-up bed on the floor free of obstructions or sharp objects.
2. Make certain the Quick Release Valve is closed. Bed should be stored with valve in
the closed and latched position. If the Quick Release Valve is open, close it by using 2
thumbs to push cover and snap into valve. Be careful to avoid pushing valve cover to
the right or left as it snaps into the valve opening.
3. Remove AC plug and cord from plastic bag and shrink wrap.
INFLATION
SERVICING OF DOUBLE-INSULATED PRODUCTS
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product, nor is a
means for grounding to be added to the product. Servicing a double-insulated product
requires extreme care and knowledge of the system, and is to be done only by qualified
service personnel. Replacement parts for a double-insulated product must be identical to
the parts they replace.
IMPORTANT: TIME TO FULLY INFLATE IS APPROXIMATELY 4
MINUTES. TO AVOID OVERHEATING AND PUMP DAMAGE, DO
NOT LET PUMP RUN CONTINUOUSLY FOR MORE THAN
5 MINUTES.
•
Pump is not intended for continuous use. Pump may stop
working or overheat if it is used for extended periods of time.
Do not use pump continuously for more than 5 minutes.
Once pump is overheat, let it rest for 30 minutes for restart.
•
Do not attempt to disassemble, repair, or service the pump.
No serviceable parts are contained inside. Contact Consumer
Service Department for repair or servicing information.
•
Avoid splashing the pump with water.
•
Never overinflate an inflatable item.
•
Unplug product when not in use.
•
Do not block air intake during operation; this could damage
the motor.
•
Always monitor the pump during use.