aero-stream AS1000-1, Installation & Operator’S Manual

Page: 19 / 56

19
© Copyright Aero-Stream, LLC 2003-2019 102821 Rev. D
Before Installation
Installation Process-Bio Brushes
1.
Obtain required state and local permits.
2.
Install a state approved water-tight tank meeting the criteria listed in
Table 2, System Requirements on page 55 using industry best practices.
3.
Install the Aero-Stream riser assembly per the riser instruction sheet.
4.
In an existing system meeting the criteria listed in Table 2, System
Requirements on page 55, have the tank pumped prior to installation
by a licensed contractor.
5.
Install a four-(4)-inch sanitary T-fitting on the outlet baffle drop pipe as
shown in Figure 2 and Figure 8, Sanitary T-Fitting on Outlet Baffle.
Note the direction of the sweep. This baffle functions as a gas deflector.
Figure 8, Sanitary T-Fitting on Outlet Baffle
6.
Locate the six-(6) screws attaching the riser pipe to the riser flange (see
Figure 9, Unscrew the fasteners about ½-inch so the threads are
exposed. These will be used to temporarily anchor the Bio-Brush ropes
during installation.
Figure 9, Mounting Screw Location Detail
IMPORTANT! Remove plastic sleeves from Bio-Brushes
®
as instructed in Installation Process