21
Spare parts and customer service
If you have any questions about the ad-
sorption-dehumidifier or require spare
parts, contact your authorised dealer or
AERIAL Service.
13 Troubleshooting
Please check the following points in the
event of a fault. If necessary contact
AERIAL Service.
WARNING!
Risk of burns, crushing
and electrocution!
Only allow the manufacturer or au-
thorised personnel to carry out re-
pairs and maintenance work.
In the event of malfunctions, switch
off the adsorption-dehumidifier and
secure it so that it cannot be
switched back on again.
Wait at least 15 seconds after
switching it off so the rotor can stop
turning.
Allow any hot components to cool
sufficiently before working on them.
CAUTION! Mucous membrane irrita-
tion!
The rotor is coated with a metal silicate;
these dust particles may irritate mucous
membranes.
Wear a protective mask and gog-
gles.
Observe any information regarding
safe handling while taking into con-
sideration the safety data sheet and
the operating instructions.
Faults
Problem
Possible cause
Remedial action
The adsorption-dehu-
midifier is not per-
forming well/removing
moisture.
Air filter is dirty. The device
is not getting enough air.
Dirty filters can damage the
appliance in the long term.
Clean the filter or replace
if necessary.
The process air inlet is
blocked.
Check process air inlet
and remove any objects
in front of it if necessary.
The adsorption-dehu-
midifier is out of or-
der/no fan noises are
heard, no air current
is perceptible at the
dry air outlet or the re-
generation air is the
same temperature as
the dry air.
The adsorption-dehumidi-
fier is switched off.
Switch on the dehumidi-
fier.
There is no power supply
to the adsorption-dehumid-
ifier.
Check the power supply.
ASE 200/300:
The desired
room humidity has been
reached.
Once the preset moisture
has been exceeded, the
adsorption-dehumidifier
switches back on auto-
matically.
Appliance faulty.
Contact the manufactu-
rer.
Summary of Contents for ASE 200
Page 135: ...135...
