20
ASE 400: Ventilating the room
The procedure without an external con-
trol system is described below. If an ex-
ternal control system is connected, the
ASE 400 can be set and operated using
that system. To do this, set the
On/Off/External switch to
and fol-
low the operating instructions for the
control system.
Procedure
1. Set the continuous operation fan
switch to .
The ASE 400 starts the fan in continuous
operation without dehumidifying.
ASE 400: Dehumidifying the room
Procedure
1. Make sure that the regeneration air
is directed out of the room via a
hose.
2. Set the On/Off/External switch to
.
3. Set the continuous operation fan
switch to .
The dehumidifier will start operating.
The adsorption-dehumidifier runs con-
tinuously.
Switching off
Procedure
1. Set the On/Off switch to ‘0’ and the
On/Off/External switch to
.
2.
ASE 400:
Set the continuous oper-
ation fan switch to .
12 Maintenance and care
WARNING!
Damage to health from
dust!
Only clean the device with com-
pressed air in open spaces.
Wear a protective mask and gog-
gles.
ATTENTION! Damage to property!
Cleaning agents can damage sur-
faces. Only use mild detergents.
Only use approved original spare
parts.
Cleaning and inspection
Procedure
1. Switch off Adsorption-dehumidifier.
2. Unplug the mains plug.
3. Remove the fastener (1) from the
cover of the air filter.
ASE 200/300:
ASE 400:
4. Remove the cover.
5. Remove and clean the air filter
(e.g. with vacuum cleaner) or
replace it.
6. Connecting the hoses/air ducts.
7. Insert a new or clean filter. Only
use an original filter.
8. Put the cover back on and secure
using the fastener (1).
9. Plug in the mains cable.
10. Switch on the adsorption-dehumidi-
fier if necessary.
1
1
Summary of Contents for ASE 200
Page 135: ...135...
