AEQ
NETBOX 32 AD / NETBOX 8 AD / NETBOX DSP
Audio over IP multichannel interfaces
35
The previous image shows an example where vumeters of the first 2 analog inputs and the first
2 AoIP Dante inputs are sent to IP address 172.31.0.22, with "Id" numbers 17, 18, 21 and 22
respectively. On the other hand, vuemeters of the first 2 digital inputs are sent to IP address
172.31.37.66 with "Id" numbers 19 and 20 respectively.
In order to configure this section you must press the associated "Edit" button (the headline of
the corresponding section changes from blue to green), make the desired configuration and
apply the changes by pressing the "Change Config." button: then the unit will reset. If you want
to cancel the changes before pressing "Change Config.", you can do it by pressing the "Cancel"
button.
3.2.2.6. "Gains" submenu.
"Gains" submenu, accessed from the drop-down menu "Administration" by clicking on the
corresponding icon, allows you to configure the input and output gains of each one of the
analog and digital audio connections, adjusting inputs to the most proper level for transmission
through DANTE network and outputs to the necessary level for destination unit reception.
This submenu appears only for NETBOX 8 and NETBOX 32 with CPU versions 1.xx.
In the case of NETBOX DSP this submenu is not shown.
In the case of NETBOX 32 there are 8 analogue inputs/outputs and 8 digital inputs/outputs.
In the case of NETBOX 8 there are 2 analogue inputs/outputs and 2 digital inputs/outputs
(the second one can be switched between DB15 connector and USB connector):
