AEQ
NETBOX 32 AD / NETBOX 8 AD / NETBOX DSP
Audio over IP multichannel interfaces
28
"External Sync" section allows you to configure the synchronization mode: whether the unit
works as "Master" (only one unit per network must be configured that way) or it’s synchronized
through IP connection ("IP Sync") or through the source connected to digital input 1 ("AES11
Sync"). The selected option will be applied when pressing "Change Configuration" button.
Confirmation is requested. In the case of NETBOX DSP the third option is not available.
"Front Test" section allows you to start a test of front level indicators, by pressing the "Start
Test" button (when test is started, the button changes to "Stop Test" and allows you to stop the
process). The front LEDs will light one by one following the green-red-yellow sequence. In the
case of NETBOX DSP this section is not shown because there are no frontal level indicators.
"Device Address" section allows you to configure the control IP parameters of the Ethernet
interface of the unit:
-
"IP": valid control IP address associated with the interface.
-
"Mask": valid subnet mask associated with the interface.
-
"Gateway": valid gateway or network gateway address associated with the interface.
-
"MAC": valid MAC address associated with the interface (this parameter is
automatically configured depending on the IP address assigned to the unit).
Once these parameters are configured, the changes will be applied by pressing "Change Ip
Address" button. Confirmation is requested.
