Button Functions.
Action button press
LED Status
Function
1x Tap (when factory reset)
Solid
Yellow
Pair Mode
Enters Z-Wave pair mode, flashes white/green 4 times within 2 seconds
1x Tap (when already paired)
Solid
Purple
Sends NIF / Excludes device
if Z-Wave controller is in unpair mode, starts
blue
reset successfully.
Press and hold [1, 2 seconds)
No LED
N/A
Press and hold [2, 5 seconds)
Solid
Red
Quick Wakeup
LED will disappear as soon as you release its button. The MultiSensor 7
wakeup report to your Z-Wave Controller to take in any queued z-wave c
waiting in your controller.
Press and hold [5, 9 seconds)
Solid
Orange
Long Wakeup Mode
LED will remain solid
Orange
upon release of its button for 5 minutes ma
told to sleep by user or z-wave controller). This will allow you to easily co
device while the sensor is used with battery power assuming your Z-Wav
does not queue the command.
Press and hold [9, 15 seconds)
Solid
Cyan
Communication Health Test
(Direct gateway communication - does not
repeaters).
This will test your MultiSensor 7 direct communication to your Z-Wave C
remain
Cyan
while it is testing.
Once finished it will become a solid color for 2 seconds as
indicate health:
Red
= Bad health, can't communicate at all.
Yellow
= Moderate health, could use improvement, some communcation
Green
= Great health
Press and hold [15, 20 seconds)
Blinking
Red
Release here to cancel Factory Reset.
Press and hold [20+ seconds)
Blue
fade in/out for 2 seconds. Factory Reset.
Important safety information.
