3.
1.
2.
Ｐｕｔ ａｌｌ ｔｈｅ ｐａｒｔｓ ｂａｃｋ ｉｎ ｒｅｖｅｒｓｅ ｏｒｄｅｒ．
4.
5.
6.
※
Ｔｈｅ ｐｏｗｅｒ ｓｕｐｐｌｙ ｍｕｓｔ ｂｅ ｃｕｔ ｏｆｆ ｂｅｆｏｒｅ ｃｈａｎｇｉｎｇ ｃａｒｂｏｎ ｂｒｕｓｈｅｓ．
9.
7.
8.
Carbon Brush
Wall-mounting Bracket
Fix the retaining screws in broken line
showed in the picture; examine the strength
and stability after works done.
The wall which you want to attach the bracket
to must be a solid wall which could bear
weight loading!
Groomers’ Third Arm
1.
2.
Fix the nozzle with the metal clamp.
Remove the retaining
screws on front cap by
cross screwdriver in arrow
direction, and open the
front cap.
Lift the little iron panel up
with flathead screwdriver,
open the brass clip which
holds the motor wire to
remove the old carbon
brushes.
Put the new brushes
in, and tighten the
brass clip with nipper
pliers to fix the
varnished wires.
Twist the little iron to a
certain angle to fix the
carbon brush brass
rear cap.
Remove the 4 wires
from the connection
terminal.
Remove the three
screws which fix the
front motor bracket one
by one.
Slide out the rear motor
bracket by fitting the little gap
on the bracket to the screws
on the housing.
After the middle rubber
ring and rear motor
bracket taken out,
remove the rear motor.
Change carbon brushed
on the rear motor
according to the
instructions in box 4, 5, 6
