AENO AAP0003, Installation And Operation Manual, Page: 26 / 39

Installation and Operation Manual
AENO AP3 air purifier
Document version: 1.0.1, aeno.com © ASBISc Enterprises PLC. All rights reserved
Page 26 of 39
Figure 8
– Examples of device placement
The air purifier enters standby mode after being plugged in. You can now control
the device using the touch control panel.
2.2 Turning the device on and off
After connecting to the mains all the indicators on the control panel light up blue
for a few seconds and a short beep sounds. Then the lights go out and the device
enters standby mode.
Press the "POWER" button to enter the activation mode. If you press this
button again, the device will stop and return to standby mode.
After activating the activation mode, select the operating mode of the device by
pressing one of the buttons:

"SLEEP" ("Sleep Mode", low speed);

"SPEED MID";

"SPEED HIGH".
Buttons are used to change the fan speed. The higher the fan speed, the faster the
air in the room is purified. In "SPEED HIGH" mode, the air in a room of up to 20 m
2
will be purified in about 0.5 hours.
The fan speeds in each mode are listed in Table 1 "Basic Technical Specifications".