Simple Logger
®
II Model CL601
13
4.4
Recording Data
NOTE:
The Simple Logger
®
II is factory configured and may be altered to fit
the users needs (see the
Configuring the Simple Logger
®
II
section inside the
DataView
®
user manual).
Once a configuration is written to the instrument, the logger will no longer
need to be connected to DataView
®
to start the configured recording.
When data is stored in the memory, the user may download the informa
-
tion onto a hard-disk
(
see the
Downloading Recorded Instrument Data
section inside the DataView
®
user manual
)
.
4.4.1 Starting a Recording Session
NOTE:
A new recording cannot be started if the memory is full.
1. Connect the instrument to the measurement source.
2. Make sure the logger is in
STANDBY
mode (see § 4.3).
3. Press and hold the
PRESS
button. When the
START
(GREEN) LED
lights up, release the button.
4. The GREEN LED double-blinks when the logger is recording.
4.4.2 Stopping a Recording Session
1. Press and hold the
PRESS
button. When the
STOP
(ORANGE) LED
lights up, release the button.
2. The GREEN LED will change from a double-blink to a single-blink,
indicating
STANDBY
mode.
The data will be retained, even if the instrument is turned OFF. The
recorded data is stored in Flash memory (maintained even in the absence
of batteries). The recorded data may be downloaded to a computer.
4.5
Downloading Recorded Data
Recorded measurements stored in the instrument are transferred to
a computer via the download command in the SLII Control Panel. For
instructions on downloading data, see the
Downloading Recorded Instru-
ment Data
section inside the DataView
®
manual.
www.
ShopAEMC
.com
Shop for AEMC products online at:
1.888.610.7664
