12
Simple Logger
®
II Model CL601
4.2
Connecting the Simple Logger
®
II to a Computer
INSTALL DATAVIEW
®
BEFORE CONNECTING TO THE COMPUTER.
Connect the Simple Logger
®
II to a USB communication port on your
computer. Refer to the computer manual to locate the USB port on your
computer.
The logger can be connected to the computer during a recording session,
however, additional battery drainage will occur to support the active USB
connection.
4.3
Turning the Unit On
Turn the instrument ON by performing one of the following:
• Press and hold the
PRESS
button for approximately 2 seconds.
Release the button after all five LEDs light up in unison.
The unit is now in the
STANDBY
mode (Green LED single-blinks).
NOTE:
If all LEDs light instantaneously, the instrument was in
SLEEP
mode.
Releasing the
PRESS
button will show the status.
• Connect the instrument to a USB port on your computer and establish
communication with the instrument using DataView
®
. The logger will
remain ON while a communication link with the SLII Control Panel is
active (provided sufficient battery power is available during the com
-
munication session).
The instrument contains protection circuitry to prevent it from being turned
on when the battery voltage is below 1.7V.
There are two thresholds for the battery voltage:
•
The first is used to indicate low battery.
The low battery indicator will
blink when the battery voltage drops below 1.8V.
•
The second is used to determine when to terminate recording and
turn the unit off.
The shutdown threshold is when the battery voltage
drops below 1.7V.
www.
ShopAEMC
.com
Shop for AEMC products online at:
1.888.610.7664
