AEMC 4000D-14, User Manual

Page: 19 / 24

Digital Flexprobe
®
Models 400D & 4000D
17
CHAPTER 5
MAINTENANCE
Use only factory specified replacement parts. AEMC
®
will not be held
responsible for any accident, incident, or malfunction following a repair
done other than by its service center or by an approved repair center.
5.1 Cleaning
Disconnect the instrument from any source of electricity.
• Use a soft cloth lightly moistened with soapy water.
• Wipe with a moist cloth and then dry with a dry cloth.
• Do not allow water or other foreign substances into the case.
• Never use alcohol, solvents or hydrocarbons.
5.2 Replacing the Batteries
Disconnect the instrument from any source of electricity.
The battery must be replaced when the symbol flashes or remains
steady on the display.
1.
Use a screwdriver to unscrew the two closing screws on the back of
the housing.
2. Replace the old battery with a new battery
(1.5V or AAA super-alkaline batteries).
3.
Close the housing; make sure that it is completely and correctly
closed.
4. Screw both screws back in.
Used batteries must not be treated as ordinary household waste.
Take them to the appropriate recycling collection point.