AEM Performance Electronics
Phone (8am-5pm M-F PST): 310-484-2322
2205 W 126
th
Street, Unit A
Fax: 310-484-0152
Hawthorne, CA 90250
Safety Warning Acknowledgement
1. Within the Warnings group, view the
WarningStatement tab.
2. Read the warning statement.
3. After reading and acknowledging the
statement, Select Yes for the
SafetyWarningAknowledgment
setting.
The VCU must be powered up and connected
to AEMCal before making this change. If you
do not acknowledge this statement, the VCU
will only allow a 0.0 N.m torque command
regardless of any other calibration settings.
Fundamental Configuration Options
There are several fundamental configuration settings
required.
1. Go to the Setup-ConfigOptions group and select
the Configuration tab.
2. Select each setting and read the Description field
for definitions and instructions.
3. Make your selections to configure the VCU for
your application.
Minimum Required Inputs Setup
The following sections describe setup of the minimum required inputs. These steps assume the inputs are connected to
the VCU and the VCU is powered up and running. Before proceeding, use the VCU pinout table in the Setup-Hardware
group, HardwarePinout tab as a reference for adding the inputs to your harness. These include:
1. Ignition Switch
2. Accelerator Pedal
3. Brake Switch
4. Drive Mode PRND inputs
5. Main HVIL Loop
6. IMD
6/3/2020, Revision C
AEM EV VCU200 User Guide
Page
9
of
15
