8
·
Continuous time data can be used for Infinity USB log file naming
·
Accelerometers supply all 3-axis acceleration data for chassis tuning
·
Ideal for road racers who want to use the gyrometer data for suspension adjustments
·
Perfect for drag racers who want G-loads and wheel stand data
·
GPS vehicle speed, heading and altitude logged for data analysis, lap comparisons
·
Status LED indicates power & GPS signal
·
Weather resistant enclosure with IP67 rated GPS/GLONASS antenna
Go to
Setup | Lap Timing...
Select the GPS button to configure for GPS lap timing. A virtual start/finish line
creation feature allows you to use the beacon input (violet wire in flying lead harness) to set a virtual start/finish
line. While driving the course, press the momentary beacon switch when you cross the start/finish line. Hold
for a few seconds until the left and right LEDs flash. The system captures the location information when you
first press the button. Holding for a few seconds eliminates the likelihood of false triggering the input. You can
define your virtual track width in the dialog window. Set to the approximate width of the track surface plus
some extra. The dash creates a start finish line the width of the Track Width/m setting perpendicular to the
heading when the start finish is set. It then checks whether the previous two points cross this line; the only
caveat being that the heading is +/- 90 degrees of the original heading.
