Troubleshooting Tips
1. The LCD panel remains blank when I press the POWER button
and can’t take pictures.
Check that the battery is correctly inserted. If it is old, replace it.
2. The camera can not take a picture.
When the FLASH indicator is on, it takes up about 20 seconds to charge
the flash light for the next shot. During this time the camera is busy and
cannot take pictures. Wait until the indicator becomes OFF.
3. Cannot download all my images from my camera to PC
The RAW memory installed in your computer may not have sufficient
storage space. Close all software programs and proceed to download
your images. If the problem persists, download images in batches and
store each batch in your hard drive before proceeding to the next batch.
Make sure all the images you want are stored prior to clearing the
camera memory.
4. I have connected the camera to the computer, but the Digital
Camera DC-132U driver says “Device not ready!”.
Make sure that the batteries are installed correctly and there is enough
power in them.
Check if the camera power is turned on. If not, turn it on and then
connect the camera to the computer again.
5. In Windows 2000, when I unplug the camera from my
computer while running Digital Camera DC-132U driver, the
computer freezes.
Unplugging the camera from your computer while running the Digital
Camera DC-132U driver will cause the computer to become unstable. Do
not unplug the camera from your computer when the camera or driver is
in use.
12
Enabling self-timer
The self-timer function allows you to let the camera take pictures 10
seconds after the shutter is pressed. To enable self-timer:
1. Press the MODE button 1 times. The self-timer icon “ ” will appear
on the status display.
2. Press the shutter and the camera will start generating beep sound.
The self-timer activation indicator on the front panel and the busy
indicator on the rear panel will both blinks simultaneously.
3. After 10 seconds, the camera will take photos automatically.
