AEG SKK818E9ZC, User Manual

Page: 17 / 24

Problem Possible cause Solution
Many food products were
put in at the same time. Wait a few hours and then
check the temperature
again.
The room temperature is too
high. Refer to "Installation" chap-
ter.
Food products placed in the
appliance were too warm. Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly. Refer to "Closing the door"
section.
The Coolmatic function is
switched on. Refer to "Coolmatic func-
tion" section.
The compressor does not
start immediately after
pressing the "Coolmatic", or
after changing the tempera-
ture. The compressor starts after a
period of time. This is normal, no error has
occurred.
Door is misaligned or inter-
feres with ventilation grill. The appliance is not level-
led. Refer to installation instruc-
tions.
Door does not open easily. You attempted to re-open
the door immediately after
closing. Wait a few seconds between
closing and re-opening of
the door.
The lamp does not work. The lamp is in stand-by
mode. Close and open the door.
The lamp is defective. Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice. The door is not closed cor-
rectly. Refer to "Closing the door"
section.
The gasket is deformed or
dirty. Refer to "Closing the door"
section.
Food products are not wrap-
ped properly. Wrap the food products bet-
ter.
Temperature is set incorrect-
ly. Refer to "Control Panel"
chapter.
Appliance is fully loaded and
is set to the lowest tempera-
ture. Set a higher temperature.
Refer to "Control Panel"
chapter.
ENGLISH 17