Problem
Possible cause
Solution
The lamp is defective.
Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice.
The door is not closed cor-
rectly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
Temperature is set incorrect-
ly.
Refer to "Control Panel"
chapter.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.
Set a higher temperature.
Refer to "Operation/Control
Panel" chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic de-
frosting process, frost melts
on the rear plate.
This is correct.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was opened too fre-
quently.
Open the door only when
necessary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrap-
ped.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set.
The "Coolmatic function" is
switched on.
Switch off "Coolmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Coolmat-
ic function" section.
The temperature in the ap-
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera-
ture.
ENGLISH
17
