4
ENGLISH
SBE 600 R, SB2E 680 R, SB2-700, SB2E 700 R, SB2E 700 RS, SB2E 705 PLUS, SB2E 750 R, SB2E 760 R
Hold the grip and open the chuck by
turning the sleeve in the ”RELEASE”
direction.
When turning the sleeve the chucking
power retention is released, after 1/4 turn
the clamping jaws open and release the
clamped tool.
Due to the high power potential of the
percussion drill the chuck might get stuck
at very high load and can not be opened
by hand.
In this case, please steady the chuck head
with a fork wrench and loosen the front
sleeve of the chuck with aid of a footprint
anti–clockwise (see illustration). The use
of a footprint will not cause any damage to
the chuck.
Always disconnect the plug from the
socket before carrying out any work on the
machine.
1.
Hold the drive shank with the open-jaw
spanner.
2.
Insert the drill chuck key in the drill chuck
and loosen the drill chuck to the left by
tapping it lightly with a rubber hammer.
3.
Mount the chuck in reverse order.
The chuck can be used for drill bits or
screwdriver bits. For this purpose, open
the chuck, insert the selected bit and
secure by tightening the chuck with the
chuck key.
To remove tools insert chuck key into one
of the three holes at the chuck mouth and
turn anti- clockwise.
For drilling to specific depth, slide the
depth gauge into the hole provided in the
handle and fasten it at the required drilling
depth.
Removing the
tool
Three jaw chuck
(according to
standard
equipment)
Changing the
three jaw chuck
Inserting tools
Setting the
depth gauge
