AEG S71360KG, User Manual

Page: 14 / 56

Problem Possible cause Solution
The appliance has no power.
There is no voltage in the mains
socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.
Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the hook of the lamp
cover.
3. Remove the lamp cover.
4. Replace the lamp with one of the same
power (the maximum power is shown
on the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Height 1850 mm
Width 595 mm
Depth 648 mm
Rising Time 20 h
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
1
2
3
14 Technical data