The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pauze - Départ/
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display
shows .
3. Touch the Start/Pauze - Départ/
Pause button again to start the
programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze - Départ/
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display
shows the desired delay time.
3. Touch the Start/Pauze - Départ/
Pause button again to start the new
countdown.
12.7 Starting a programme
Touch the Start/Pauze - Départ/Pause
button to start the programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.8 The ProSense
Technology load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze - Départ/
Pause button, the maximum declared
load indicator goes off, the indicator
flashes, the ProSense Technology starts
the laundry load detection:
1. The appliance detects the load in the
first 30 seconds, the indicator
flashes, the drum rotates shortly.
2. At the end of the load detection, the
indicator stop flashing. The
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
is
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ/Pause
button to start the programme again. The
ProSense Technology phase can be
repeated up to three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense Technology
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
The ProSense Technology is
not available with some
programmes, such as Wol -
Laine, programmes with
short cycles and without
washing phase.
ENGLISH
25