AEG LB1360, User Manual

Page: 31 / 76

Problem Possible solution
The washing results
are not satisfactory.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Too much foam in the
drum during the wash‐
ing cycle.
• Reduce the quantity of detergent.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
• Make sure that the flap is in the correct position.
• Make sure you have used the detergent dispenser according
the indications given in this user manual.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
15. CONSUMPTION VALUES
15.1 Introduction
This user manual reports two different tables in
order to favour a gradual passage from a regulation
to the other:
• Regulation EU 1061/2010, valid up to 28th of
February 2021, is related to the Energy Efficiency
classes from A+++ to D,
• Regulation EU 2019/2023, valid from 1st March
2021, is related to the Energy Efficiency classes
from A to G set by Regulation EU 2019/2014.
See the web link www.theenergylabel.eu for
detailed information about Energy Label.
15.2 Legend
kg Laundry load. h:mm Programme duration.
kWh Energy consumption. °C Temperature in the laundry.
Litres Water consumption. rpm Spin speed.
% Remaining moisture at the end of spinning phase. The higher is the spin speed,
the higher is the noise and the lower is the remaining moisture.
ENGLISH 31