Problem
Possible solution
The appliance does
not fill with water prop‐
erly.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is cor‐
rect.
• This problem may be also caused by the clogged drain circuit.
Please contact the Authorised Service Centre.
• Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
The appliance does
not drain the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• This problem may be caused by the clogged drain circuit.
Please contact the Authorised Service Centre.
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without drain
phase.
• Set the drain programme if you set an option which ends with
water in the tub.
Internal fail. No com‐
munication between
electronic elements of
the appliance.
• The programme was not finished properly or the appliance
stopped too early. Switch the appliance off and on again.
• If the alarm code appears again, contact the Authorised Serv‐
ice Centre.
The mains supply is
unstable.
• Wait until mains supply is stable.
If the display shows other alarm codes, deactivate and activate the
appliance. If the problem continues, contact the Authorised Service
Centre.
In case of different problem with the washing machine check the
table below for possible solutions.
ENGLISH
29
Summary of Contents for LB1360
Page 1: ...USER MANUAL EN User Manual 2 Washing Machine DE Benutzerinformation 36 Waschmaschine LB1360 ...
Page 74: ......
Page 75: ......