41
Connecting to the water supply
Important!
•
This appliance
must not
be connected to the hot water system.
•
When connecting it, use only new hose kits.
•
Only connect the appliance to the drinking water supply. Rain water
or water for industrial use may only be used if it fulfils the require-
ments of DIN1986 and DIN1988.
•
Do not kink or crush the water inlet hose or drain hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
2
=0.1MPa) and may
be a maximum of 10bar (=100N/cm
2
=1MPa).
–
If more than 10bar: Connect a pressure reduction valve.
–
If less than 1bar: Disconnect the appliance end of the inlet hose from
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.
Water inflow
A 1.50 m long pressure hose is supplied with the appliance.
If a longer water inlet hose is required, only original hoses are to be
used. The Customer Care Department stocks hose kits of different
lengths.
3
Sealing rings are either inserted in the nuts of the threaded hose fitting
or are included as spare parts . Do not use any other type of sealing
rings.
Important!
All threaded hose fit-
tings must only be tightened by
hand.
1.
Connect the hose with the right-an-
gle connector to the machine.