Operating Instructions
33
No water runs in.
Fault code
E10
ap-
pears. The indicator
RINSE+ flashes.
Water tap is closed.
Open the water tap.
Filter in screw connection of
the intake hose is blocked.
Close the water tap. Unscrew
the hose from the water tap,
remove the filter and clean it
under running water.
Water tap is blocked with
limescale or is faulty.
Check water tap and have it
repaired if necessary.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are not correctly set.
Adjust in accordance with
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the op-
eration of the machine.
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used.
Meter the detergent exactly
in accordance with the
manufacturer's information.
Problem
Possible Cause
Remedy
