15
GB
Exchange fuse on the 12 V
vehicle-connection
j
Release (and remove) the knurled ring
11
, by
turning it against the clockwise direction.
j
Remove the defective fuse and replace it
with a new one, max. 10 amps.
j
Screws the knurled ring
11
again firmly, by
turning it in the clockwise direction
Error tracing
the manometer display
2
does not shine.
Check, if the12 V vehicle- connection
10
is
inserted completely and correct and voltage
is on. (POWER-LED on 12 V vehicle-connec-
tion
10
shines).
Check, if the POWER-LED on 12 V vehicle-
connection
10
shines. If not, check the fuse
of the 12 V vehicle-connection
10
as well as
the fuse on the 12 V-socket of the vehicle.
Despite switched on On- / OFF-switch
3
(in position ) the device does not start
the pumping procedure.
Turn the ignition key / ignition into the first
position (do not start the engine)
the device does not finish the pre-set
pump procedure automatically.
Ensure that you have followed the operating
instructions correctly.
Ensure that you have pre-set the correct
value.
the power cable and / or the 12 V vehicle-
connection gets hot.
Danger of short circuit - Disconnect the
device immediately from the circuit.
the manometer-display
2
shows the
wrong value or is not readable.
Ensure that the device has measured the ac-
tual tyre pressure, (see chapter „Tyre pressure
check“).
Pull off the 12 V vehicle- connection
10
for
at least 5 seconds from the 12 V-socket of the
vehicle and remove the valve connection
15
from the vehicle. Wait until the manometer-
display
2
shows 0,0 again. Re-start the
procedure again.
the pump procedure is running, but the
tyre does not inflate.
Ensure that the valve-connection
15
is fixed
correctly on the valve of the vehicle.
Ensure that the tyre does not have a puncture.
Maintenance and care
The device is maintenance-free.
WarnIng!
Always separate electrical de-
vices from the power supply, before you carry
out service etc.
j
Switch off the device .
j
Pull of the 12 V vehicle connection
10
from
the 12 V-socket of your vehicle.
j
Clean the device with a dry cloth. Do not use
solvents or other aggressive detergents
under any circumstances.
Service
WarnIng!
Leave the repair of the
device to qualified technical personnel to
repair.
Thus the safety of the device is guaran-
teed and maintained.
WarnIng!
Leave the exchange of the
plug or the connecting cable always to quali-
fied technical personnel.
Thus the security of
the equipment is guaranteed and maintained.
Warranty
The general guarantee conditions refer to
production and material defects.
Operation / Error tracing / Maintenance and care / Service / Warranty
97136_AEG_Kompressor_Content_EU.indd 15
05.11.10 13:50