If floor is not level, adjust
levelling legs to suit
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Gap on both sides should be
equal, & no greater than
5 mm per side.
Secure dishwasher with
brackets or screws provided
Min. 400 mm straight
section
600mm max
300mm min
400mm
min
DISHWASHER
SINK
POWER OUTLET
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
Dimensions of the appliance and the
cavity:
600 mm
597 mm
820-880 mm
818-878 mm
14.1 Adhesive steam
protection
Clean the bottom part of the kitchen
worktop and apply the adhesive plastic
film along the entire width.
600 mm
E
14.2 Adjusting the height of
the appliance
1. Remove the adjustable plinth.
2. To adjust the front height, turn the 2
front feet counterclockwise to raise
the appliance.
www.aeg.com
24