Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2
Activating the rinse aid
dispenser with the multitab
option activated
1.
Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
‘SETTING AND STARTING A PRO-
GRAMME’.
2.
Turn the programme knob until the
display shows two horizontal status
bars.
3.
Press and hold
Multitab
and
Delay
at the same time until the indicators
,
, and
start to flash.
4.
Press
Delay
.
• The indicators and go off.
• The indicator
continues to
flash.
• The display shows the setting of
the rinse aid dispenser.
Off
On
5.
Press
Delay
again and again to
change the setting.
6.
Deactivate the appliance to confirm
the setting.
11.
TECHNICAL INFORMATION
Dimensions
Width / Height / Depth
(mm)
596 / 818 - 898 / 575
Electrical connection
Refer to the rating plate.
Voltage
220-240 V
Frequency
50 Hz
Water supply pressure
Min. / max. (bar / MPa)
(0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity
Place settings
12
Power consumption
Left-on mode
0.10 W
Off-mode
0.10 W
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
ENGLISH
15