6
APPLICATIONS
(Use only for the purpose listed below.)
1. Sawing wood.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can exceed
85 dB (A). In this case, sound insulation and hearing protection
measures must be taken by operator.
ATTACHING AND
REMOVING THE BLADE (FIG. 1, 2, 3, 4)
WARNING:
Be sure to disconnect the tool from the
power supply before attaching and removing the saw
blade. Be sure that teeth of the saw blade are point-
ing upward at the front of the tool.
ATTACHING
1. Pressing the spindle lock button, turn the hex. screw head
bolt with the wrench until the gear shaft locks. (Fig. 1)
2. Loosen the hex, screw head bolt by turning the wrench
counterclockwise while pressing the spindle lock button.
(Fig. 1)
3. Remove the hex. screw head bolt and the outside flange.
(Fig. 1)
4. Retract the lower guard back with the lower guard lever as
far as possible toward the upper guard. (Fig. 2)
5. Place the saw blade against the inner flange on the gear
shaft and then replace the outside flange and the hex.
screw head bolt. (Figs. 2 & 3)
6. Press the spindle lock button again, tighten the hex. screw
head bolt by turning the wrench clockwise while pressing
the spindle lock button. (Fig. 4)
7. After tightening the hex. screw head bolt, release the
spindle lock lock button.
REMOVING
1. Pressing the spindle lock button, turn the hex. screw head
bolt with the wrench until the gear shaft locks.
2. Loosen the hex. screw head bolt by turning the wrench
counterclockwise while pressing the spindle lock button.
3. Remove the hex. screw head bolt and the outside flange.
4. Retract the lower guard back as far as possible toward the
upper guard, then remove the saw blade.
Summary of Contents for CS 66
Page 10: ...NOTES ...
Page 11: ......
