9
To remove the wire deflector:
1. Remove the pin that holds the deflector on the tool.
2. Using a 10 mm wrench, hold the nut in place. With a
5 mm hex key, loosen and remove the bolt.
3. Remove and discard the wire deflector.
NOTE:
There is a gasket attached to the wire
deflector where the nut screws onto the bolt. The
gasket should not be removed from the wire deflector.
To attach a new wire deflector:
1. With the bolt inserted through the hole in the tool,
install the wire deflector gasket over the bolt.
2. Using a 5 mm hex key, hold the bolt in place. With
a 10 mm wrench, tighten the nut securely. Do not
overtighten.
3. Insert the long end of the wire deflector through the
nose piece as shown. Wrap it over so that the holes
meet. Insert the pin through both holes in the wire
deflector and into the hole in the tool. Make sure the
pin is securely inserted into the tool.
ACCESSORIES
To order parts and maintenance kits, call
Australia - 1300 361505
New Zealand - 0800 279624
WARNING
Current attachments and accessories available for
use with this tool are listed above. Do not use any
attachments or accessories not recommended by the
manufacturer of this tool. The use of attachments or
accessories not recommended can result in serious
personal injury.
