2.
Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
12.11
Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1.
Deactivate the appliance.
2.
Remove the fuses from the fuse box
or deactivate the circuit breaker.
The top lamp
1.
Turn the lamp glass cover
counterclockwise to remove it.
2.
Remove the metal ring and clean the
glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Attach the metal ring to the glass
cover.
5.
Install the glass cover.
The side lamp
1.
Remove the left shelf support to get
access to the lamp.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
www.aeg.com
64
EURO Appliances - euappliances.info