![AEG BES356010B User Manual Download Page 32](http://html.mh-extra.com/html/aeg/bes356010b/bes356010b_user-manual_12844032.webp)
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is
free to move. Make sure,
that both hinge-arms are in
the same position
(approximately 70° angle).
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
11.7
Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1.
Turn off the oven.
Wait until the oven is cooled down.
2.
Disconnect the oven from the mains.
3.
Put a cloth on the bottom of the
cavity.
The top lamp
1.
Turn the lamp glass cover to remove
it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
12.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1
What to do if...
Problem
Possible cause
Remedy
The oven does not heat up.
The oven is deactivated.
Activate the oven.
The oven does not heat up.
The clock is not set.
Set the clock.
The oven does not heat up.
The necessary settings are
not set.
Make sure that the settings
are correct.
The oven does not heat up.
The fuse is blown.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
The lamp does not operate.
The lamp is defective.
Replace the lamp.
The core temperature sensor
does not operate.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
www.aeg.com
32