AEG BE3013021, User Manual

Page: 25 / 28

Removing and cleaning the door glass panels
1.
Remove the door.
2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not
set
Control the settings
The oven does not heat up The fuse in the fuse box is re-
leased
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
The oven lamp does not oper-
ate
The oven lamp is defective Replace the oven lamp
Steam and condensation settle
on the food and in the oven
cavity
You left the dish in the oven
for too long
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends
The display shows “12.00” A power cut Reset the clock
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
B
What to do if… 25