AEG B 89090-5, User Manual, Page: 26 / 64

2. Install the left end of the aluminium
plate ”A” in the recess in the holder “B”.
Install the holder “B”. Make sure that all
components are attached correctly.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Solution
The oven does not operate The appliance is not correctly
connected or/and the mains
supply to the oven is not on
Check if the appliance is cor -
rectly connected and the mains
supply to the oven is on.
The oven does not operate The oven is switched off.
Touch to switch on the
oven.
The oven does not operate The clock is not set Set the clock. Refer to "Setting
the clock".
The oven does not operate The fuse in the fuse box is re -
leased
Check the fuse. If the fuse is
released more than one time,
contact a qualified electrician.
The oven does not heat up The "Demo" function is acci -
dentally activated (symbol
appears on the display)
1. In the Off position touch
for about 5 seconds.
The oven turns to stand by
and then off again. An au -
dible signal sounds.
2. Within 5 seconds touch
and at the same
time. Hold them touched
until an audible signal
sounds. The operation is
successful if
symbol
disappears when you
switch on the oven again.
The oven lamp does not oper -
ate.
The oven lamp is defective Replace the oven lamp.
A
B
26 What to do if…