AEG ABE81226NC, User Manual

Page: 11 / 16

Problem Possible cause Solution
The compressor operates
continually. Temperature is set incorrect-
ly. Refer to "Operation" chap-
ter.
Many food products to be
frozen were put in at the
same time. Wait a few hours and then
check the temperature
again.
The room temperature is too
high. Refer to climate class chart
on the rating plate.
Food products placed in the
appliance were too warm. Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
Food products are not wrap-
ped properly. Wrap the food products bet-
ter.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor. Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set. The FROSTMATIC function
is switched on. Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
DEMO appears on the dis-
play. The appliance is in demon-
stration mode. Keep the OK button pressed
for approximately 10 sec-
onds until a long sound is
heard and display shuts off
for a short time.
The temperature in the ap-
pliance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
ENGLISH 11