AEG 944188601, User Manual

Page: 45 / 64

CAUTION!
Carefully handle the glass, especially around the edges of the front panel. The glass can
break.
Step 1 Open the oven door to the first opening position (approximately 70° angle).
Step 2 Hold the door trim (B) on the
top edge of the door at the
two sides and push inwards
to release the clip seal.
1
2
B Step 3 Pull the door trim to the front
to remove it.
Step 4 Hold the door glass panels on
their top edge one by one and
pull them up out of the guide.
Step 5 Clean the glass panel with
water and soap. Dry the glass
panel carefully. Do not clean
the glass panels in the dish‐
washer.
Step 6 After cleaning, do the above
steps in the opposite se‐
quence.
Step 7 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of
the door may overheat.
11.12 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Before you replace the lamp:
Step 1 Step 2 Step 3
Turn off the oven. Wait until
the oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of
the cavity.
45/64
CARE AND CLEANING