•
Correct functioning of your appliance does not only
depend on product quality, but on correct installation
by a qualified professional.
•
Never remove or damage stickers, warning labels or
nameplates attached to the appliance.
•
A qualified technician carrying out the installation is
obliged to observe applicable national standards and
regulations concerning connection to the water
distribution system and the electric network. The
manufacturer is not responsible for any unprofessional
or incorrect installation.
•
Check that the specifications written on the
appliance’s identification plate are the same as those
of the electrical power supply.
•
This appliance is manufactured and tested in
accordance with valid regulations.
•
The operating water pressure (minimum and
maximum) must be between 0,1 bar (0,01 MPa) and 10
bar (1,0 MPa).
•
To prevent scalds while using the water heater, always
check the water temperature and adjust as needed
before use.
In the case of faults, a peak temperature of up
to 99 °C may briefly occur in the system.
1.3
Special information
•
When permanently connected to the power supply
using a dedicated junction box, the appliance must be
able to be isolated from the mains power supply by an
isolator that disconnects all poles with at least 3 mm
contact separation.
•
The power cable may only be replaced (for example if
damaged) by a qualified contractor authorised by the
manufacturer, using an original spare part.
•
Secure the appliance as described in chapter "3.3".
•
Observe the maximum permissible pressure (see
chapter "9.4").
ZZZDHJFRP