AEG 10648, Instructions For Use Manual

Page: 19 / 72

English 19
Connect the terminal clamps of the
leads in the following order:
1. Positive lead (red) to positive termi-
nal of drained battery.
2. Plus lead (red) to positive terminal
of good battery.
3. Negative lead (black) to negative
terminal of good battery.
4. Negative lead (black) to the nega-
tive pole on the drained battery,
or to a suitable mass (e.g. engine
block) on the vehicle.
Caution!
Connect this earthing point to the ve-
hicle earth as far away from the battery
as possible to avoid igniting explosive
gas which may be present.
Starting
1. Start the engine of the good vehicle
and run at a medium engine speed.
2. Start the engine of the vehicle
with the drained battery (starting
attempt max. 15 seconds - wait at
least one minute between additional
attempts to start).
3. after successfully starting the
vehicle engine with the drained bat-
tery wait 2 to 3 minutes until it runs
smoothly.
JuMPSTARTING
Preparations
1. Be sure to follow the indications on
jumpstarting inside the vehicles‘
operator’s manuals.
2. Set the parking brake on both
vehicles.
3. Set gearstick to neutral, for auto-
matic transmissions to P.
4. Switch off ignition on both vehicles
and all devices.
5. Do not disconnect the drained
battery from the vehicle’s electrical
system.
Connecting
Place the jumper leads so they will not
be tangled in moving parts inside
the engine compartment.
1
2
3
4