AEG Electrolux DD 8793, Operating And Installation Manual, Page: 9 / 20

9
Using the Remote Control
The remote control may operate in humid
environments, but not when placed on wet
surfaces.
Selecting the Suction Speed position the
remote control vertically near the cook top area
and rotate clockwise to increase the suction
speed, and anticlockwise to decrease the suction
speed.
Turning on the Light , press the remote control
from the top downwards once for suffused lighting,
again for full lighting, and again to turn off the light.
Remote Control
Maintenance
Clean the remote control using non
abrasive detergents.
Follow the instructions below in order
to replace the batteries for the remote
control :
- Using a small screwdriver, raise the
cover on the base of the remote
control, in order to access the battery
compartment.
Remove the battery holder, and
replace 4 new batteries type ..394 of
1.5V.
Place the batteries in order in the battery holder (see Fig. 5) taking care
to respect the polarities indicated on the base of the upper section of
the remote control.
Warning!
If the remote control doesn’t work after installation (yet the control ball
works correctly), do the following:
1. Place the remote control on the work surface near the hood.
2. Disconnect the hood from the mains.
3. Reconnect the hood to the mains.
Follow this procedure whenever the remote control doesn’t work for no
apparent reason (e.g.: dead battery).
Fig. 4
Fig. 5