AEG Electrolux 34942 G, Instruction Booklet

Page: 7 / 32

7
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting
a pan on the pan support.
To light a burner, turn the relevant knob
anticlockwise to maximum position ( ), then
push it down to ignite the burner. Upon ignition,
adjust the flame as required.
If the burner does not ignite, turn the control knob
to zero, and wait for at least one minute before trying
to light the burner again.
When switching on the mains, after installation
or a power cut, it is quite normal for the spark
generator to be activated automatically.
In the absence of electricity, ignition can occur without the electrical device; in this
case, approach the burner with a flame, push the relevant knob down and turn it anti-
clockwise until it reaches the “maximum” position.
To ensure maximum burner efficiency, you should only use pots and pans with a flat
bottom fitting the size of the burner used (see table).
Burner minimum maximum
diameter diameter
Triple-crown (ultra-rapid) 160 mm 260 mm
Large (rapid) 160 mm 240 mm
Medium (semi-rapid) 120 mm 220 mm
Small (Auxiliary) 80 mm 160 mm
Operation
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective materials, which
were put on in the factory.
A - Burner cap
B - Burner crown
C - Ignition electrode
Triple crown burner
A
B
C