12
When an error is detected, this product
will restart automatically.
This product will be inoperable for around 2
minutes after the restart just as when the power
is turned on.
About the automatic status detection
function
When this product malfunctions due to exoge-
nous noise, etc. for 30 seconds or more, the
product will automatically reset and will return to
normal state. When the product is reset, initializa-
tion will be carried out as when the power of the
product is turned on. When the product repeat-
edly resets, exogenous noise level around the
product may be high and that may cause mal-
function. Contact your dealer for instructions.
Product disposal/transfer
Data saved on this product or a storage device
used with this product may lead to personal
information leakage.
When it is necessary to dispose or give this
product to someone, even when for repair, make
sure that there is no data on this product.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury. Do not
use strong abrasive detergent when cleaning
this product. Otherwise, it may cause discolor-
ation. When using a chemical cloth for clean-
ing, read the caution provided with the chemi-
cal cloth product.
Cleaning the lens
Use a lens cleaning paper (used to clean cam-
era lenses or lenses of spectacles). When using
solvent, use an alcohols solvent and do not use
a thinner or a glass cleaner.
Transmission interval
Image transmission interval may become slow
depending on the network environment, PC
performance, shooting subject, access num-
ber, etc.
Periodically images on the screen appear
to be distorted
When the camera is installed in a location where
it is subject to small vibrations (for example, when
it is installed near devices that vibrate), images
may appear distorted and stretched lengthways.
This phenomenon is a characteristic of image
pickup devices that use CMOS sensors and is
caused by the relationship between the periodic
movements of the camera and the timing that the
image sensor reads images. This is not a prob-
lem with the camera. To reduce the possibility of
this phenomenon occurring, install the camera in
a secure location.
About SD memory card
• To remove the SD memory card from the
unit, press the [Setup] button on the “Live”
page, select the [SD memory card] tab,
and set the SD memory card operation to
“Not use”. Then, remove the SD memory
card. Alternatively, hold down the SD ON/
OFF button for about 2 seconds. When
the flashing SD MOUNT lamp goes out,
you can remove the SD memory card.
• When using an SD memory card, format it
using this product. Recorded data on the
SD memory card will be deleted when for-
matted. If an unformatted SD memory card
or an SD memory card formatted with
other devices is used, this product may
not work properly or performance deterio-
ration may be caused. Refer to the
Operating Instructions on the provided
CD-ROM for how to format an SD memory
card.
• When some SD memory cards are used
with this product, the product may not work
properly or performance deterioration may
be caused. Use the SD memory cards rec-
ommended in page 44.
• When using an SD memory card supporting
Class 10 of the speed class, use a UHS-I
(Ultra High Speed-I) compliant card.