30
Switching on the device, adjusting the power
Turn the adjustment knob and position it outside the "OFF" zone to the desired power level.
The display shows the selected value to indicate to the user that the hotplate is operational and
ready to send power to the large utensil.
There are 20 power levels between 1 and 20 which correspond to power levels between
50W<Power<8000W.
As long as the utensil compatible with induction technology is placed on the cooking zone, the
display permanently shows the desired level. It is possible at any time to adjust the power level
between
50W<Power<8000W.
As soon as the pan is removed from the hotplate, the display indicates the absence of the pan by
a flashing light.
If the display flashes when the cookware covers the hotplate: this means that:
OR: the material of the saucepan is incompatible with induction technology
EITHER
: The diameter of the pan is too small to be detected
ELECTRICAL CONNECTION
1
1 /
Insert upwards the end of a flat screwdriver. The maximum
diameter of the rod must be 4mm.
2
2 /
Then lift the screwdriver to allow the lowering of the
spring
-
loaded jaw of the terminal block contact
.
To be able to insert and connect each conductor in the terminal block:
Repeat the previous steps for each wire to be
connected
Be careful not to push the wire end too far into the jaw of the terminal block!!!
!
NO
YES
