Page: 4
718022
5M Bell Tent instructions
• Take the centre pole (making sure the “D” ring is at the
top end) through the door, find the centre of the roof
which is indicated by the main “cone” in the roof and
push the pole vertical/upright until it is 90 degrees to
the ground as shown in the diagram to the left.
• Then take the door ‘A’ frame pole inside the tent and
carefully place the pole in the doorway. The feet
on the poles should sit inside their pockets on the
groundsheet (as shown in the diagram to the left)
and the top of the door ‘A’ frame pole has a guide pin,
which goes though an eyelet located at the top of the
door (again as shown in diagram to the left).
Pitching Instructions
Details on how to pitch your bell tent.
Step 1
• Clear away any debris (stones/sticks etc) from your desired camping
location trying to avoid tree’s where possible due to the sap and
other droppings.
• Unpack your tent and move to the side all accessories leaving
you with the main canvas and groundsheet which if not already
attached please do so now.
• Move the tent to your desired location and rotate making sure the
door is facing in the desired direction as shown in the diagram to
the left.
• Peg down the groundsheet and the side wall (as shown in diagram to the left ) using
the pegs supplied. making sure to pull the groundsheet tight as you go around the
tent.
• Repeat this until every pegging point oin the groudnsheet has been pegged down.
St
ep 2
Step 3
Centre pole, with D ring shown
