R3131 Spectrum Analyzer Operation Manual
3.3 Menu Function Descriptions
3-19
3.3.4
CONFIG Key (Configuration)
This section describes the menu displayed when the CONFIG key is pressed.
Copy Dev
Displays the Copy Dev menu which is used to select the device
for outputting the screen data.
Printer
Selects the printer as the destination for the screen data.
F.Disk
Selects the floppy disk drive as the destination for the screen
data.
Reset File No.
Resets the file numbers files are saved under when saving to a
disk.
Printer Config
Displays the Printer menu used to set up the printer.
Print CMD PCL/ESCP/ESCP-R Switches between printer types.
PCL:
Allows you to use a PCL printer.
ESCP:
Allows you to use a ESC/P printer.
ESCP-R:Allows you to use a ESC/P Raster printer.
Copy Mode GRAY/ B/W
Toggles the printer output mode between gray scale and mono-
chrome modes.
GRAY: Sets the printer output mode to gray scale.
B/W:
Sets the printer output mode to monochrome.
Copy Size HALF/FULL
Toggles the printer output size between HALF and FULL.
HALF: Approximately the same size as the screen display.
FULL: Prints in A4 size horizontally.
F.Disk Config
Displays the F. Disk menu used to format the floppy disks for
use with the analyzer.
Format F.Disk
Initializes the disk currently in the drive.
GPIB
Displays the menu used to set the parameters for GPIB control.
Address
Allows you to set the GPIB address.
Display ON/OFF
Toggles the remote control parameter display on or off.
ON
: Displays all parameters and measured values.
OFF
: Displays traces only (this function can also be control-
led by the panel settings).
Apr 10/98
