- 12 -
www.advateklights.com
PixLite R4D-S User Manual V211013
Figure 9: Connecting Receivers to Transmitter
5.4 - Connecting Pixel LEDs
The pixel lights are connected directly via the 4 pluggable screw terminal connectors
on the rear of the unit. Each connector is labelled with its output channel number (1-
4) and on the top of the lid the pin-out is clearly marked. Simply wire your lights into
each screw terminal and then plug them into the mating sockets.
Since the PixLite R4D-S product has data only outputs (no pixel clock lines), it takes
advantage of the transmitter's Expanded Mode. In expanded mode, the clock lines
are used as data lines instead. This means the receiver effectively has twice as many
pixel outputs than the PixLite R2 (4), but half as many pixels per output can be run.
The cable length between the output and the first pixel should not exceed 15m.
Figure 10: Pixel Output Pinout
